Vista 20p user guide

Skip to main content. Roll over image to zoom Right click on thumbnail to save image. Requires a pro for pricing, installation and warranty Toggle This product is sold exclusively through our Professional Partners. This product is temporarily out of stock. Item will ship when available. Find a Retailer. Coming Soon. Requires Pro for installation. Back To Top. Get Started. Works With. Replacement Parts. Related Products.

Sell Train Install Promote. View All View Less. Failure to have the installation performed by a qualified professional could result in substantial property damage, and even severe personal injury or death, and Resideo will not be responsible for any damages or injuries resulting from not observing this warning.

Product Overview. How to get started. If the delay time is more than 96 seconds, then enter 97 and then the system will give you a delay of seconds. Note: Both partitions must have a delay time programmed, even if you do not have a 2nd partition. A summary screen will be displayed. Enter the Zone Type ZT. Refer above or go to page in the Installation and Setup Guide for the exact types. Enter the partition number PT 1 or 2. Report Code RC should be left at The summary will show 10 though this is correct.

At this time we will not enter Alpha Descriptors. Then enter 1 when asked to delete zone. We also recommend adding a resistor to the zone as well. Set to Confirm will be displayed on the screen.

This means: Are you installing wireless devices? You will trip the sensor you are entering. If not hit and reenter. The keypad will beep 1 time for confirmation letting you know the code was successfully changed.

This can be done from any partition. The keypad will beep 1 time for confirmation letting you know the code was successfully entered. Using the number pad, enter the hour, then minutes.

Press 1 for PM. The following are ways to add keypads to your system. Keep in mind keypads can be addressed 16 to 23 with no duplicates in the addresses. The keypad should come defaulted at 31, but we will default the keypad to make sure everything is correct. For the second keypad this would be 17, 18 for the third keypad, etc. You will need to activate address you used i.

Use the Installation and Setup Guide for assistance on enabling your keypad address on page